Ask the Expert: What are the leading wheel alignment factors?

April 10, 2013
Improper wheel alignment results in excessive or irregular tire wear, hard steering, poor driveability and premature failure of suspension parts.

Q: What are the leading wheel alignment factors?

A: Wheel alignment is the positioning of the inter-related angles of a front suspension, rear axle or housing to give the maximum amount of tire life, steering ease, steering stability and increased life of suspension components. Improper wheel alignment results in excessive or irregular tire wear, hard steering, poor drivability and premature failure of suspension parts. Several alignment factors must be considered to achieve proper wheel alignment. The top four factors are toe, tracking, camber and caster.

Toe and tracking are the two most critical alignment settings for front-end tire wear. Bee Line gauging equipment incorporates lasers to measure for proper steer axle toe. Toe is adjustable to reduce tire wear and shimmy in the steering wheel. Excess or too little toe will make the front wheels fight each other, resulting in feathering, diagonal wear or excessive shoulder wear. An out-of-toe condition leads to rapid tire wear. Tracking misalignment also will cause inside and outside wear of the steer tires. Tracking, or thrust, is gauged relative to the vehicle centerline.

Camber and caster are the third and fourth most critical alignment settings for front end tire wear. Camber — the inward or outward tilt of the top of the wheel — is important for several reasons. Its main purpose is to keep the tire flat on the road while the vehicle is loaded and in motion. If camber is excessive, it will create shoulder wear. Caster is the forward or rearward tilt of the king pin. Extreme caster settings can cause handling problems, leading to driver fatigue.

Information provided by: Bee Line

About the Author

Howard Williams | Corporate Technical Sales Specialist, Bee Line Company

Howard Williams is a corporate technical sales specialist at Bee Line Company. He has lead the computerized wheel alignment and truck frame correction factory and on-site training courses for Bee Line for more than 20 years. With his professional technical training and hands-on experience, Williams also oversees the corporate technical sales efforts for Bee Line.

Sponsored Recommendations

How to Properly Lubricate your Air Tools

Learn how to properly lubricate your AIRCAT air tools to keep them running at peak performance. Discover essential daily maintenance and storage techniques, along with the right...

Save Time with Standard's Kits & Multipacks

Stock up on essential repair kits! Discover how Standard's multipacks simplify repairs and reduce downtime.

Fuel Injection Training – Pro Tips for Techs

Choosing the right fuel injector matters. Learn best practices for selection and related component recommendations.

ABS Sensor Insights – Get the Right Fit Every Time

ABS sensors are critical to vehicle safety. Learn how they interact with electronic systems and how to choose the best replacement.

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!