TSBs

Miata Requires Reprogram

Sept. 10, 2021

This bulletin applies to 2010-2012 Mazda MX-5 Miata vehicles.

This bulletin applies to 2010-2012 Mazda MX-5 Miata vehicles with VINs lower than JM1NC******226801 (produced before June 22, 2012). Some vehicles may experience a check engine light on with DTC P2096:00 (target A/F feedback system too lean). This is caused by the improper control logic. To correct the problem, the control logic has been changed.

Reboot the IDS to clear memory before reprogramming.

Using IDS 89.03 or later software, reprogram the PCM to the latest calibration.

When performing this procedure, Mazda recommends using the “Power Supply” mode in the battery management system to keep the battery up to capacity. If a different charger is used, make sure it does not exceed 20 amps to avoid damaging the VCM.

About the Author

Information courtesy of Mitchell 1

Information for Technical Service Bulletins comes from ProDemand, Mitchell 1's auto repair information software for domestic and import vehicles. Headquartered in San Diego, Mitchell 1 has provided quality repair information solutions to the automotive industry since 1918.

About the Author

Mike Mavrigian | Motor Age Editor

Mike Mavrigian has written thousands of automotive technical magazine articles involving a variety of specialties, from engine building to wheel alignment, and has authored more than a dozen books that crisscross the automotive spectrum. Mike operates Birchwood Automotive, an Ohio shop that builds custom engines and performs vintage vehicle restorations. The shop also features a professional photo studio to document projects and to create images for articles and books.