This bulletin applies to 2012 Jeep Wrangler vehicles equipped with a 3.6L engine. The MIL may be on, with DTC P0108 (manifold absolute pressure sensor circuit high) set active or stored.
This bulletin applies to 2012 Jeep Wrangler vehicles equipped with a 3.6L engine. The MIL may be on, with DTC P0108 (manifold absolute pressure sensor circuit high) set active or stored.
Updating the software with release 13.01 or higher will resolve the issue.
Be sure to install a battery charger to prevent battery voltage dropping below 13.2 volts or rising above 13.5 volts during the reprogramming process. Clear all DTCs following the re-flash.
Learn how electronic parking brake actuators have replaced manual systems and now play a key role in advanced safety features like automatic emergency braking. This WIYB Training...
Not all fuel injectors are created equal. In this WIYB Training Series, we compare Standard® Fuel Injectors against OE, low-cost imports. See why precision engineering and rigorous...
Carrying active OEM subscriptions for all manufacturers is not possible for many shops. However, access to this software is required for certain modern vehicles and repairs, and...
Learn how to properly lubricate your AIRCAT air tools to keep them running at peak performance. Discover essential daily maintenance and storage techniques, along with the right...
Voice Your Opinion!
To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!
