Ram ProMaster MIL

March 12, 2019
This bulletin applies to 2014 Ram ProMaster 1500 vehicles equipped with a 3.6L engine and built on or before Sept. 12, 2013. A MIL may be on, with DTC P0606 (internal control processor) stored in the PCM.

This bulletin applies to 2014 Ram ProMaster 1500 vehicles equipped with a 3.6L engine and built on or before Sept. 12, 2013. A MIL may be on, with DTC P0606 (internal control processor) stored in the PCM.

Using a scan tool (wiTECH), verify that all engine systems are functioning as designed. If DTCs other than P0606 are found, record and address before continuing.

1. Install a battery charger to prevent battery voltage dropping below 13.2 volts or rising above 13.5 volts during the flash process. Reprogram the PCM with the latest software.

2. After programming, clear any DTCs that may have set during the flash.

Sponsored Recommendations

Tesla service, repair, and diagnostics

Keep update-to-date on how to maintain your customer's Tesla vehicles.

Tool Review: Ascot Supply 3/4" Drive 600 ft-lbs Split Beam Torque Wrench, No. 168-00600

Reviewed by Eric Moore, manager at DeMary Truck in Columbus, Ohio.

Diagnosing an engine misfire

Recognizing a misfire is the easy part; the challenge is determining its cause.

The ‘Iron Giant’

This technician spent two and half years putting together his ‘giant’ of a toolbox setup.

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!