SKF proper torque for a ConMet PreSet hub video

Jan. 27, 2014

This video shows how to properly torque a ConMet PreSet hub on a steer axle application.

Related

SKF

May 5, 2008

Latest in Diagnostics and Drivability

Figure 1: The EPS is housed entirely in the steering column assembly on this example displayed. Although this is a typical configuration, it doesn’t mean every vehicle is configured this way.

Going in the right direction with electronic power steering

Brandon Steckler

Dec. 3, 2024

Scan Tool

Diagnostics and Drivability

Roadmap to repair

Dec. 3, 2024

The broken exhaust valve spring is the cause of the driveability fault. Keep in mind that a broken spring can present intermittent faults or faults that only occur under certain operating conditions. It’s important to realize that a broken spring can still allow a perfectly passing compression test (or relative compression test) but fail a running test miserably.

Solved: GMC Yukon with low compression

Brandon Steckler

Dec. 2, 2024

Figure 1: A correlation of the CKP sensor signal to that of the CMP sensor(s) signals can be a great way of inferring camshaft timing. Keeping in mind the limitations of the test, it only truly reflects the timing of the reluctors. If they have lost their reference from their respective shafts, the timing will not be on.

A tight squeeze in a Ford Escape

Brandon Steckler

Dec. 2, 2024

Figure 1 — Fueling Strategy using ANNs

Diagnostics and Drivability

A new era for technicians

Nov. 26, 2024